AEG Refrigerator Fault Codes: A Complete Guide – Zest
This guide contains everything you’ll need to figure out what error your AEG Fridge is trying to communicate. Whether it’s a noisy fridge, a smelly fridge, or your fridge is too hot. Remember to call an engineer if you’re not able to fix it yourself, and check the common issues below the table for some other useful information. For other valuable articles, check out the rest of our helpdesk articles here.
Error Code | Meaning |
---|---|
E0 | No error |
E1 | Evaporator sensor damaged |
E2 | Room temperature sensor damage (install on the display board) |
E4 | Room temperature sensor damaged (installed on the power display board) |
E5 | 0 degree compartment sensor damaged |
Er | http://IM/RAM Error. Check J4-4, J4-5, and J4-6 Connectors on the Icemaker board. Check the J4 connector at the Main Control board. Check 15 pin inline connector at the control board, Pin #’s 4,9 & 14. If all connections test good, control board. |
t3 | TH3 Sensor (open or short) Go to flow chart for Ice t3 |
CE | IM Com Lost Go to flow chart 50C. Put into service mode to verify. |
SY – EF | Evaporator Fan Failure |
SY – CE | Communication Error |
SY – CF | Communication Failure |
F7 | It might be that the power supply has been interrupted for a period or that the door has been too long or not properly closed. |
F2 | It is possibly a faulty thermostat. |
So those are the error codes for your AEG fridge, and these should help you diagnose the issue and with the help of an engineer, get it fixed!
Common Fridge / Freezer Faults
Here is a shortlist of some of the most common fridge/freezer problems, for a little extra help.
- Freezer too hot – This is most likely either the compressor or the evaporator fan that has gone wrong. Check both and call an engineer.
- Water leaking on the floor – This could be a clogged drain hose which you could have to clear manually. Try draining the hole from the inside using warm water though.
- Fridge cycling too often – Unplug the refrigerator and clean the condenser coils. It could be this that caused the issue or it could be that your fridge temperature is too low.
- The fresh food compartment is warming up – This issue could be caused by either a diffuser fan that’s clogged with ice or your evaporator fan could need a new motor.
- A build up of frost in the ice dispenser – Check the damper door for any dirt or debris that may be causing air to leak through. It may be a case of simply cleaning up the dirt, or you may need to buy a replacement part.
Samsung Dishwasher Error Codes: Troubleshoot Common Issues
Hotpoint dishwashers are known to be reliable appliances. However, when they do break down, it can be tricky to troubleshoot the problem. This article will go over some of the most common Hotpoint dishwasher error codes and what they mean.
5 Tell Tale Signs Your Oven Needs Replacing
While reusing and repairing your appliances is always the ultimate goal, there comes the point where your oven needs replacing. Our handy guide outlines five of the main signs your oven may need replacing.
Deep Cleaning Your Dishwasher: A How To Guide
Our dishwashers work tirelessly to ensure our dishes emerge spotless after every meal. However, in the hustle and bustle of daily life, we often forget that our dependable dishwasher [...]