Miele Dishwasher Error Codes

Water/heating temperature sensor short circuited.

Water/heating temperature sensor open circuited.

The non return valve is incorrectly positioned in the dishwasher.

The drain pump cover is positioned incorrectly in the dishwasher.

The stopcock is not open or the inlet filter is soiled.

The stopcock is not open or the inlet filter is soiled. 

The circulation pump is blocked. In longer breaks between wash/rinse cycles (lasting weeks or months at a time), the pump may become dry and stick together.

Technical fault. Water intake fault – pump pressure level switch or heating level switch.

The on-site drainage connection is situated lower than the guide path for the lower basket rollers in the door. 

For example, in the case of a dishwasher installed at a height, the on-site drainage connection may be situated lower than the guide path for the lower basket rollers in the door.

The stopcock is not open.

The inlet filter is soiled.

The water inlet hose is kinked.

The flow pressure at the water connection is lower than 50 kPa (0.5 bar).

Water intake valve defective.

Flow meter defective.

Heating relay contact fault.

Desired temperature fault.

Boiling protection.

Door lock does not open.

Door lock switch defective.

Electronic module fault.

Electronic module fault.

Mains frequency registration fault.

Electronic module fault.

Pump pressure level switch fault.

Excess quantity of detergent or rinse aid dispensed.

Speed sensor fault.

Water path control unit fault.

Circulation pump fault.

Circulation pump fault.

The circulation pump is blocked.

There may be a technical fault.

The Waterproof system has been activated. The current programme is cancelled and te drain pump switches on.

The circulation pump is blocked.

There may be a technical fault.

Circulation pump fault.

Water intake fault.

There is a technical fault.

The salt reservoir flap in the door is not closed.

There is a technical fault.

Turbidity sensor fault.

Load recognition inactive.

Lack of rinse aid.

Insufficient salt.

There is a technical fault.

The water inlet is blocked or restricted.

The inlet filter is soiled.

The flow pressure at the water hose is too low.

A predefined number of programme sequences have been started, you will receive a message telling you that the filter needs cleaning.

Electronic module fault.

Electronic module fault.

Electronic module fault.

The AutoDos system is blocked. 

There is a fault in the AutoDos.

The bottom spray arm is blocked or the nozzles of the bottom spray arm are clogged. The AutoDos function is automatically deactivated during the programme sequence because the AutoDos detergent outlet cannot be completely flushed out.